2 Wheel Pro Street 5200#
|
Rules locked 2026,2027,2028 General Rules: |
||||||||||||||
|
|
||||||||||||||
|
ENGINE: |
||||||||||||||
|
Gas only, NO alcohol, E85, or fuel additives. |
||||||||||||||
|
Naturally aspirated engines only. |
||||||||||||||
|
MAX cfm carb, 4150/4160 Holley flange only. (No Dominators, King Demons, SV1, or split carbs.) |
|
|||||||||||||
|
MAX 485 cubic inches |
|
|||||||||||||
|
Small blocks are NOT required to be pumped. |
|
|||||||||||||
|
All pumping must be done at the track. |
|
|||||||||||||
|
Blocks and heads MUST be cast iron. |
|
|||||||||||||
|
Aftermarket blocks and heads are allowed |
||||||||||||||
|
No aluminum blocks and heads are allowed. |
||||||||||||||
|
SFI approved harmonic balancer. |
||||||||||||||
|
MUST use SFI approved flywheel. |
||||||||||||||
|
Motor must be mounted within 6? of original V8 mounts. |
||||||||||||||
|
Must have a catch can for the radiator. |
||||||||||||||
|
DRIVETRAIN: |
|
|||||||||||||
|
Dual disc clutches are allowed. |
||||||||||||||
|
No reversers or drop boxes allowed. |
||||||||||||||
|
¾ Ton rear end or less - no ho110 our square tube rockwell rear ends. Rear End must have a MAX of 11.5in Ring Gear |
|
|||||||||||||
|
No planetaries allowed. |
||||||||||||||
|
Manual transmission MUST use a SFI approved bellhousing (blow proof). |
||||||||||||||
|
Must use a block saver plate. |
||||||||||||||
|
If bellhousing has been altered in any way (cut, torched, or welded) you must also run an SFI approved transmission blanket. |
||||||||||||||
|
Automatic transmissions MUST be covered by an SFI approved transmission blanket. |
||||||||||||||
|
HITCH SETUP: |
||||||||||||||
|
36” minimum hook point from center of rear axle. |
||||||||||||||
|
48” maximum hook point from centerline of rear axle. |
||||||||||||||
|
Bolted clevis or hitch point must have 3.5” hole. |
||||||||||||||
|
Hitch height is 30” maximum. |
|
|||||||||||||
|
Must have sled stops that extend at least 8” past the rearmost point of the truck. |
||||||||||||||
|
CHASSIS: |
|
|||||||||||||
|
Rigid suspension is permitted. |
||||||||||||||
|
Front weights must not extend greater than 60” from centerline of front tires. |
||||||||||||||
|
DOT tires only. 35×12.5 maximum manufacturers tire size, no cut, siped, or barred tires allowed. |
||||||||||||||
|
All U-joints and chains must be covered with a 360” loop and be at least 6” wide constructed of 1/8” steel or 3/16” aluminum. |
||||||||||||||
|
Max of 140in. Wheelbase |
||||||||||||||
|
ALL THE ABOVE RULES WILL BE STRONGLY |
||||||||||||||
|
ENFORCED DUE TO YOUR SAFETY AND THE SAFETY |
||||||||||||||
|
OF OTHERS. THE OFFICIALS’ DECISIONS ARE FINAL! |
||||||||||||||
|
**The Head of Class/Tech Official for each class will enforce |
||||||||||||||
|
all of the rules! Every vehicle will be teched on a random basis |
||||||||||||||
at some point throughout the season.**
|
at some point throughout the season.**
|